I just started using the Aardvark I2C/SPI Host Adapter and I heard that batch scripting is supported. Can you show me examples of how to do this?  I’ll be working with I2C devices.

I plan to use the Cheetah SPI Host Adapter to generate traffic on a 4-wire Mode 0 SPI bus at 8 MHz. The communication pattern is specialized. The protocol being used is not a full duplex. The master sends 3 bytes on the MOSI and then reads 3 returned bytes on the MISO. It looks like the Cheetah only returns the bytes seen on MISO when there is a write on MOSI, essentially assuming only a Write/Read operation.

We’re working on a small production system that we need to upgrade to make it run faster.  The system uses the Cheetah SPI Host Adapter to send SPI messages with C#.NET 2013 and Cheetah Software API.  It sends 10 sets of 128 byte frames in 2 milliseconds and resets the Slave select (SS1).

I just started using the Data Center Software with my new Beagle USB 480 Power Protocol Analyzer to analyze the communication from my PC to an MCU using CDC. It works great and it’s easy to use – but I have one question.