I have a project that involves integrating and testing devices on a CAN bus, and I'm looking at your Komodo CAN Solo and Komodo CAN Duo Interfaces. Which one would be best to use for executing read and write commands simultaneously from different threads? Also, what software package do you recommend using for this application?

We need to analyze the USB communication between a smartphone and a prototype board equipped with a custom embedded USB chip. We'll be testing the USB link over various periods, from 5 minutes to 24 hours, maybe longer. The tests will be run at USB full speed. What we need is to:

The Promira  Serial Platform, together with the SPI Active Level 1 and SPI Active Level 2 Applications make an excellent tool for programming low voltage Dual SPI Flash devices. You can use the Promira platform with the Control Center Serial Software, and see how easy it is to provide up to 200 mA at the selected voltage level, and program and verify your target SPI device.

We have the Beagle 5000 v2 Protocol Analyzer - Standard Edition and we have used it for triggering for USB 3.0 traffic.  For example, we have set  it up with the  trigger to capture an ACK (acknowledgement) packet,  but we don't see how to set it up to trigger on NRDY (not ready).  Is that possible with the standard edition, or do we need get an upgrade for Complex Triggering?

I have been using the Aardvark I2C/SPI Host Adapter as an SPI Master for several projects. It's worked very well for me, but I'm having some challenges with my current project. I basically need to work at faster SPI speeds to work with the current SPI timing parameters. Is there a way to set the timing parameters on the Aardvark adapter, or is there another SPI adapter that would work better? The table below lists the timing parameters I will be working with:

I just got backed up with a lot of projects and I need to monitor and debug USB data sent by various USB devices. I'll be working with low and full-speed USB 2.0, about 1.5Mbps to 12Mbps. I'm looking into your USB protocol analyzers - which one do you recommend? I have a lot of experience, but I'm fairly new to working with USB.

I am working on a new design and of part of the requirement is to interface a CAN device to an I2C device. It would be really helpful to emulate that environment - do you have something that is a CAN to I2C translator, or any suggestions on how to do that?

We are looking for a way to look at the full-speed USB traffic that will be exchanged between two embedded devices. These devices go into standby mode when they are not used. We have found a problem - sometimes the resume command is lost and the device does not wake up again.